ALROC BSC-25-40 Bonded Semicon Removal & Stripping Tool | Video
Published 21 Jan 2021
INSULATION REMOVAL & STRIPPING TOOL
BY ALROC
MV HV Medium & High Voltage Cables
The below video shows the Alroc BSC-25-40 cable tools used by MV-HV jointers to remove the semi-con screen to prepare the cable ready for the installation of joints, terminations or connectors.
Cable preparation is essential to the performance and stability of MV-HV cable joints and terminations – if cables are prepared incorrectly using sub-standard tools or basic hand tools then the risk incidence of cable failure is increased.
The BSC-25-40 cable tools manufactured by Alroc enable the cable jointer to remove bonded semicon from MV cables and are predominantly used by MV-HV cable jointers.
The following instructions detail how to use the BSC-25-40 insulation removal and stripping tool safely and effectively.
- Set up the handle of the Alroc BSC-25-40
- Grease the cable by the cable jointer
- Set up and tightening of the cable jointing tool on the MV cable
- Loosen the blade, adjust it and then lock it
- Start the bonded semicon removal 1/3 white (insulation) and 2/3 black (bonded semicon)
- Wind the chip around the MV HV cable
- Loosen the jointing tool to 25mm and 40mm
Alroc Cable Tools 11kV 33kV MV HV
ALROC
For more than 30 years, ALROC has been engineering, designing and manufacturing cable jointing tools, cable preparation tools and cable fixing solutions to establish the most complete product range in the following areas:
- LV cable
- MV cable
- HV cable
- Optical Fibre cable and tube
- Telecomunications cable
- Coaxial cable
- Steel gas pipe
- Cable holding and fixing solutions
Jointing & Preparation Tools For Cable Jointers & Linesmen Working On MV-HV-EHV Cables
THORNE & DERRICK
Thorne & Derrick are national distributors of LV, MV & HV Cable Installation, Jointing, Substation & Electrical Equipment – servicing businesses involved in cabling, jointing, substation, earthing, overhead line and electrical construction at LV, 11kV, 33kV, 66kV and EHV. Supplying a complete range of power cable accessories to support the installation and maintenance of low/medium and high voltage power systems:
- Slip-on Cable Terminations
- Cold-shrink Cable Terminations
- Heat-shrink Cable Terminations
- Cable Joints – Heat & Cold-shrink
- Separable Connectors (Euromold)
- Surge Arresters & Switchgear/Transformer Bushings
Key Product Categories: Duct Seals | Cable Cleats | Cable Glands | Electrical Safety | Arc Flash Protection | Cable Jointing Tools | Cable Pulling | Earthing | Feeder Pillars | Cable Joints LV | Joints & Terminations MVÂ
