Ellis Patents Emperor ER67-74 Trefoil Cable Cleats
Emperor Cable Cleats
Trefoil Cable Cleats
Cable Cleat Maximum Short Circuit Test Level 156/195/235kA
Cable Cleat Spacing 600/300/225mm
Ellis ER67-74 Emperor Cable Cleats manufactured by Ellis Patents from stainless steel and are ideal for single core cable applications in trefoil formation where the highest level of short circuit withstand are required – suitable for LV (Low Voltage), MV (Medium Voltage) and HV (High Voltage) power cable circuits.
11kV 33kV 66kV
Ellis Patents ER67-74 cable cleats are suitable for securing trefoil power cables between 67-74mm overall cable diameter offering rapid installation and the ultimate protection against the harshest environmental conditions and short circuit protection faults on medium/high voltage power cable and substation systems – note the cable cleats are not specified according to voltage but a range of application and installation factors calculated according to IEC61914.
The cable cleats are available in a range of sizes with range taking ability to suit cables in single way or trefoil formation.
Emperor cable cleats are compliant with the requirements of London Underground Standard 1-085. Product Register No. 362. Also approved according to DNV GL
Substation Electrical Equipment Distributors –HV Cable Joints & Terminations
Emperor Cable Cleats form part of the Ellis Patents range of trefoil cable cleats – also available in stainless steel Emperor single cable cleats for cable diameters ranging from 32-150mm.
Ellis Cable Cleat ER67-74
Technical Specification
- Cable Cleat Diameter Min 67mm
- Cable Cleat Diameter Max 74mm
Ellis Patents Emperor ER67-74 Trefoil Cable Cleats
Ellis patents ER67-74 Cleat Dimensions
- Width 169mm
- Height 158mm
- Depth 54mm
- P 75mm
- 2 x M10 + 1 x M12
- Weight 850g
Trefoil Cable Cleat Selection Table
Specification details for Ellis Patents Emperor ER67-74 cable cleat for trefoil cable applications:
Ellis ER67-74 Cable Cleats – Dimensions
EMPEROR CABLE CLEATS – INSTALLATION INSTRUCTIONS
 |
 |
 |
 |
| 1. Remove the closing flange nut. | 2. Remove the base pad (if required) and fix the cleat to support structure using either the single central or two outer fixing positions. | 3. Replace the appropriate pad and install the cables. | 4. Close the hinged arm and refit the flange nut (18mm socket required). The head of the screw is held in position so that only a single power tool is required to tighten the nut from one side. |
Important. Do not over tighten the cleat. The liner should be in contact with the cable but does not need to be so tight that the cable bulges at either side of the liner.
Ellis Patents Emperor ER67-74 Trefoil Cable Cleats – Data SheetDownload
