11kV-33kV 3M Premium Cold Shrink Cable Joints – MV Medium Voltage

View Sub Products

11kV-33kV 3M Premium Cold Shrink Cable Joints – MV Medium Voltage

11kV-33kV 3M Premium Cold Shrink Cable Joints – MV Medium Voltage

3M Premium Cold Shrink Joints are used by many power utility companies throughout the global as their go to cable jointing solution.

This medium voltage premium range offers a built in semi conductive electrode eliminating the need for tape and ensuring a smooth and consistent installation.

Unlike heat shrink alternatives, the cold shrink cable joints allows a molecular permanent set that ensures constant radial pressure is exerted on the cable for the full life span.

Covering almost any cable configuration and size, this range can provide a solution for voltage classes up to 72kV (Umax) and has been widely tested to a variety of standards across the world.

Cold Shrink

3M Premium Cold Shrink Cable Joint

3M Premium Cold Shrink Cable Joint

3M Premium Cold Shrink Cable Joint Series Kits are available in 11kV and 33kV.

3M Premium Cold Shrink

Cable Joints Features

  • Built in semi conductive electrode
  • Simple installation – Easier to use in enclosed areas
  • Safe installation – No torches or heat required
  • Less room for jointer error
  • Extensive quality and factory testing programme
  • Lower installed cost – compared to many competitive products
  • Accommodates a wide range of cable sizes
  • Rated from 3.6/6.6(7.2)kV up to 66/69(72)kV

The Simple Application Of A 3M Cold Shrink Cable Joint

Cold Shrink Cable Joints Cold Shrink Cable Joints Cold Shrink Cable Joints Cold Shrink Cable Joints
1. Park the 3M Cold Shrink splice body onto the prepared cable, connect the cores and clean thoroughly. 2. Thoroughly grease the connected cable in preparation for the splice body. 3. Once in position, begin to remove the inner coil from the joint body. 4. For extra peace of mind, take advantage of the fact that splice body position is easily checked.
Cold Shrink Cable Joints Cold Shrink Cable Joints Cold Shrink Cable Joints Cold Shrink Cable Joints
5. Place the earth stocking over the splice body. Ground and secure with 3M Constant Force Springs. 6. Insulate the constant force springs with Scotch 23 Rubber Splicing Tape and then overlay with Scotch Rubber Mastic Tape 2228. 7. Position the pre-parked 3M Cold Shrink Outer Protection Tube over the stocking and begining to remove the inner supporting core. 8. Continue to remove the inner core until the outer tube is fully shrink, completing the cable joint.

 

Also:  3M Cold Shrink Cable Terminations for medium and high voltage 11kV 33kV 66kV cable terminating.

 ➡ Should you require customer service or technical support on the selection or specification of LV MV HV Cable Accessories please contact us – view the full range of 3M Premium Cold Shrink Cable Joints below.

For LV Low Voltage Cables | Cold Shrink Cable Joints | Cold Shrink Cable Abandonment | Cold Shrink Tubes

3M Cold Shrink

3M Cold Shrink

Cold Shrink Terminations 3M

Thorne & Derrick International | MV HV Joints, Terminations & Cable Connectors