Ellis 1A-18N Aluminium Cable Clamps

Ellis 1A-18N Aluminium Cable Clamps

Ellis Cable Clamps

Single Cable Clamps & Cleats

Ellis 1A-18N single hole cable cleats are manufactured by Ellis Patents from aluminium and are generally used to cleat, clamp and support LV Low Voltage power cables in dry industrial or outdoor unpolluted applications – for cable installations in harsh, hazardous area and medium/high voltage (MV-HV) applications refer to stainless steel cable cleats for excellent corrosion resistance and the highest levels of short circuit fault protection.

Ellis Patents 1A-18N cable cleats are suitable for securing single-way power cables between 46-51mm overall cable diameter – the one hole cable clamps are tested in line with IEC61914 International Standard “Cable Cleats for Electrical Installations”.

1 Hole Aluminium Cable Clamps form part of the Ellis Patents range of single cable cleats – also available as aluminium 2 hole single cable clamps to suit armoured/unarmoured cables with an overall cable diameter between 38-168mm.

Technical Specification

  • Cable Clamp Diameter Min 46mm
  • Cable Clamp Diameter Max 51mm
Ellis 1A-18N Aluminium Cable Clamps

Ellis 1A-18N Aluminium Cable Clamps 46-51mm

Ellis patents 1A-18N Clamp Dimensions

  • Width 77.3mm
  • Height 67.0mm
  • Clamp Depth 41.4mm
  • E 13.5mm
  • 1 x M 10 Clamp Fixing Holes
  • Weight 155g

SINGLE CABLE CLEAT SELECTION TABLE

Specification details for Ellis Patents 1A-18N Aluminium 1 Hole Single Cable Clamps for single cable applications:

Cable Clamp Part Number Min Dia (mm) Max Dia (mm) W (mm) H (mm) D (mm) E (mm) Clamp Fixing Holes Pack Qty Weight (g)
1A-18N 46 51 77.3 67.0 41.4 13.5 1 x M10 1 155

Ellis 1A-18N Aluminium Cable Clamps

1 Hole Single Cable Clamp Installation Instructions
Position the collar and the 2 screws (not supplied) on the stand Install the cable Place the other half of the clamp. Secure with 1 screw and 1 washer (not provided) and tighten Do not overtighten the cable clamp. The clamp must be in contact with the cable but it does not have to be so tight that the cable is bulging each side of the lining.
1. Position the cable clamp and the 2 screws (not supplied) on the stand 2. Install the cable 3. Place the other half of the clamp. Secure with 1 screw and 1 washer (not provided) and tighten 4. Do not overtighten the cable clamp. The clamp must be in contact with the cable but it does not have to be so tight that the cable is bulging each side of the lining.
Ellis Patents

See Ellis Patents for further details about cable cleats for LV-HV cable support and retention.