Single-Phase Plastic CNE Cable Joint 4sqmm to 35sqmm

Single-Phase Plastic CNE Cable Joint 4sqmm to 35sqmm

• Product Category: Low Voltage LV Cable Joint
• Kit Type: Resin Cable Joint
• Application: Service Cut & Test Joint
• Manufacturer: Sicame
• Kit Number: SBJ2/UPN

Cable Joint Installation Instructions

Sicame SBJ2/UPN

For details of cable preparation, the installation of mechanical connectors and associated components refer to the relevant sections of the UK Power Networks LV Jointing Manual opposite.

All dimensions in millimetres (mm).

• Prepare the service cable using the plastic joint shell as a guide.
• When the cable is ready to be put back together, connect all the copper wires together with the MF4/34A connectors. Use additional copper wires from a spare piece of cable of equivalent size, if there is gap between the cut ends.
• Reconnect the two halves of the phase conductor using a MF4/28i connector.
• Fit the cable joint shell, checking for a minimum clearance of 10mm between the joint shell and the completed cable joint
• Fill the cable joint shell with the correct amount of Prysmian JEM resin as shown in the table below

Cable Jointing Materials

♦ Note: LV Cable Joints are subject to change according to tender contract awards, manufacturer joint kit amends and new cable applications – always check with Thorne & Derrick that the kit referenced is the current approved and available cable joint.

Cable Joints | Low Voltage LV | Resin | Cold Shrink Joints | Heat Shrink Joints | 600V 100V Cables

Data Sheets

• Cable Joints LV – UK Power Networks LV Cable Jointing Manual – Version 4 I 2015
  Download