Cembre TC04N Cutting Head (Up To 45mm Diameter Overhead Lines)
Cembre TC04N Cutting Head (Up To 45mm Diameter Overhead Lines)
Cembre TC04N is a hydraulic cutting head tool with quick automatic coupler for connection to a hydraulic pump with a working pressure of 10,000 psi max.
TC04N cutting head features the same cutting capability as the Cembre HT-TC041N cable cutting tool.
The tool weighs 3.9kg and has an application range suitable for cutting copper and aluminium cables having a maximum diameter of 45mm.
Cembre TC04N Cutting Head
User Instructions
- Cembre TC04N cutting head is equipped with a “self-lock” quick male coupler which can be connected to a pneumatic or electric pump
- Insert the conductor between the blades, up to the desired cutting point. For running conductor, release latch and open the tool head
- Fully retract the lower cutting blade before attempting to open the tool head
- With the conductor on the lower cutter blade, close the tool head and fully secure the latch
- Before commencing the cutting operation ensure that the latch is fully secured: partial closure may damage the tool head
- Operate the pump to advance the lower cutter blade.
- Make sure the blades are exactly positioned on the desired cutting point; otherwise re-open the blades and re-position the cutting head
- Continue operating the pump to close the blades and progressively cut the cable
- Cutting head has been specifically designed for cutting copper or aluminium cable, do not cut steel ropes or steel reinforced cables
- To open the blades, fully discharge the oil pressure from the pump
- Recommend only Cembre Lugs & Connectors are used with Cembre tooling
CEMBRE TC04N
TECHNICAL SPECIFICATION
| Cembre TC04N Cutting Head Specification | |
| Tool Width | 100mm |
| Tool Length | 311mm |
| Oil Necessary | 61cm³ |
| Weight | 3.9kg |
| Nominal Pressure Of Hydraulic Cutting Head | 700 bar (10,000 psi) |
Cembre TC04N Cutting Head – Hydraulic Cutting Tool
Cembre TC04N provided with a special steel case VAL 04 to safely transport the cutting head and prevent damage
➡ For Cembre electrical connections, see Cable Crimps, Lugs & Connectors
Contact T&D to discuss crimping cables at MV-HV, including 11kV-33kV, to ensure correct Cembre tool, lug/splice and die set selection – visit battery crimping tools for repetitive crimping of cables without strain injury or worker fatigue.
Full range of battery cable cutting tools also available.
Cembre TC04N Cutting Head (Up To 45mm Diameter Overhead Lines)Download
