Ellis Vulcan VRT+12 Cable Cleats

Ellis Patents Vulcan VRT+12

Ellis Cable Cleats

Single Cable Cleats

Cable Cleat Maximum Short Circuit Test Level 104/132kA – Cleat Spacing 600/300mm

Ellis VRT+12 Vulcan Cable Cleats are manufactured from corrosion resistant stainless steel for high voltage and hazardous area industries – the compact cleat design is suitable for clamping industrial LV-HV power cables including 11kV and 33kV cables depending on short-circuit calculations according to IEC61914 calculations.

Ellis Patents VRT+12 cable cleats are suitable for securing single-way power cables between 100-125mm overall cable diameter.

The NEW Twist Foot Design from Ellis Patents provides reduced installation times and labour savings when installing cable cleats.

The cleats are available in a range of sizes with range taking ability to suit cables in single or trefoil formation.

Vulcan Cable Cleats form part of the Ellis Patents range of single cable cleats – also available in stainless steel Vulcan+ trefoil cable cleats for cable diameters ranging from 19-101mm.

Ellis VRT+12 Vulcan

Cable Cleats

  • Cable Cleat Diameter Min 100mm
  • Cable Cleat Diameter Max 125mm
Ellis Patents Vulcan VRT+12

Ellis Patents Vulcan VRT+12

Ellis patents vulcan VRT+12 Cleat Dimensions

  • Width 152mm
  • Height 177mm
  • Depth 54mm
  • P 50mm
  • Weight 460g

Single Cable Cleat Selection Table

Specification details for Ellis Patents Vulcan VRT+12 cable cleat for single cable applications:

Vulcan+ Cable Cleat Part Number Single Cable Range Dimensions Weight (g)
Min Dia (mm) Max Dia (mm) W (Max) (mm) H (Max) (mm) D (mm) P (mm) Base Holes
VRT+12 100 125 152 177 54 50 3 x M10 460

 

Ellis Patents Vulcan+ Cable Cleats - Dimensions

Ellis Vulcan VRT+12 Cable Cleats – Dimensions

 

Vulcan+ Cable Cleats – Installation Instructions

Installation instructions for single way cables using Vulcan+ cleats manufactured by Ellis Patents:

Bolt the cleat to the support structure using either the single central or two outer fixing positions Install the cables, when necessary remove the removable bas pad to allow for the larger cables in the cleats range Remove the flange nut. Bend the two edges of the cleat around the cables until they are parallel. Locate the screw into adjacent hole and replace the flange nut Tighten Flange Nut
1. Bolt the cleat to the support structure using either the single central or two outer fixing positions 2. Install the cables, when necessary remove the removable base pad to allow for the larger cables in the cleats range 3. Remove the flange nut. Bend the two edges of the cleat around the cables until they are parallel. Locate the screw into adjacent hole and replace the flange nut 4. Tighten flange nut

WARNING – Do not over tighten the cleat. The liner should be in good firm contact with the cable but does not need to be so tight that the cable bulges at either side of the liner.

Ellis Patents

See Ellis Patents for further details about cable cleats for LV-HV cable support and retention.