Euromold 440PB Coupling Connector 11kV 24kV
Euromold 440PB is a screened separable tee connector specified to terminate and connect medium/high voltage cables in the following voltage classes:
- 6/10 (12kV)
- 6.35/11 (12kV)
- 8.7/15 (17.5kV)
- 12/20 (24kV)
- 12.7/22 (24kV)
- 18/30 (36) kV
- 19/33 (36) kV
- 20.8/36 (42) kV
The Euromold 440PB coupling connector with 800A current rating is designed for Interface C and covers voltages from 12kV to 42kV with a maximum conductor size of 630sqmm.
Euromold 440PB separable coupling connectors are designed to connect all polymeric screened cables to suit CENELEC Interface Type C (800amp) equipment bushings up to 42kV.
Designed to connect polymeric insulated cables with a copper wire screen but can be used on wire armoured, copper tape screen cables with the use of additional screen earth kits and accessories.
Connector accessories include: dead-end receptacle, dead-end plug, stand-off plug and earthing plug for type C interfaces.
- Manufacturer – Nexans Euromold
- MV HV Equipment Bushing Connector – Interface C
- Maximum Operating Current – 800A (Amps)
- Voltage Classes – 12kV 24kV 36kV 42kV Maximum
- Terminate & Connect Cables – Polymeric XLPE EPR
- Conductor Cross Section Sizes – 185-630sqmm
- Applications – MV HV Switchgear, Transformers, Motors
➡ See complete range of Nexans Euromold Connectors
EUROMOLD 440PB Specification
|Current Ir (A)||Conductor sizes (sqmm)|
- Interface designed to fit 400TB/440TB connector
- Bus for 440PB
- Conductive EPDM insert
- Insulating EPDM layer moulded between the insert and the jacket
- Conductive EPDM jacket
- Conductive EPDM cap
- Basic insulating plug
- Conductor connector (hexagonal crimping, deep indent crimping or bolted)
- Cable reducer
- Earthing lead
- Threaded M16 stud for equipment bushing
The thick conductive EPDM jacket provides a safe to touch screen which ensures safety for personnel, cables and electrical equipment in medium/high voltage installations.
Euromold 440PB Selection Table
For Screened MV HV Coupling Connectors
Select the Euromold ordering part number which positions the cable most central to the minimum and maximum core insulation diameter, then substitute X using the table below, according to the conductor size (sqmm) and type (copper or aluminium). Order Euromold MT connector kit to enable termination of copper tape screened MV-HV cables in voltage range 11kV (12kV) to 42kV – suitable for copper wire screened cables. Add a ‘K’ for use up to 24 kV, add an ‘M’ for use up to 36 kV, add a ‘P’ for use up to 42 kV.
The complete Euromold 440PB coupling connector kit comprises the following components – cable lubricant, wipers, installation instructions and crimp chart.
|Dia. over core insulation (mm)|
|Aluminium Conductor||Aluminium & Copper Conductor||Copper Conductor|
|DIN Hexagonal Crimp||Deep Indent Crimp||Bolted||DIN Hexagonal Crimp|
Euromold | Connect | Joint | Terminate MV HV Cables – view our complete range of HV Joints & Terminations in heat shrink, cold shrink, push-on and plug-in versions.