Roxtec RS Cable Transit Frame

Roxtec RS Cable Transit Frame

Sealing Cables & Pipes

Roxtec RS Cable Transit Frame is a round seal for single cable or pipe entries in metal sleeves or core drilled holes – the Roxtec cable seal have a split construction making it easy to install around existing cables or pipes, available with or without cores.

The Roxtec frame parts are assembled to construct different sizes and combinations of openings to accommodate and seal LV-HV cables and pipes. Suitable for installation also around existing multiple or single cables and pipes.

Roxtec round cable transit frames are used to provide a reliable cable sealing ensuring safety, efficiency and long-term operational reliability – Roxtec cable seals protect against fire, gas, water, dusts, pests, blast load and electromagnetic interference.

➡ Visit Cable Transits to view the complete range of sealing systems for cable and pipe entries on cabinets, switchgear, electrical enclosures and substations (LV 11kV 33kV 66kV 132kV) – see Rectangular Cable Seals for sealing round type cable ducts and pipe entries.

Roxtec RS Cable Transit Frame

Roxtec RS Cable Transit Frame

Installing Roxtec RS Cable Transit Frame

Contact T&D should you require support on the installation of Roxtec RS cable transit frames:

Roxtec RS Cable Transit Frame - Installation Instructions RS25-200

Roxtec RS Cable Transit Frame – Installation Instructions RS25-200

1. Remove any dirt in the sleeve/hole
2. Pull the cable/pipe through
3. Adapt the cable seal to the cable/pipe by peeling off layers from the halves until you reach the gap seen in pic.4. The halves may not differ by more than one layer
4. Try to achieve a 0-1.0 mm gap between the two halves when held against the cable/pipe

Roxtec RS Cable Transit Frame - Installation Instructions RS25-200

Roxtec RS Cable Transit Frame – Installation Instructions RS25-200

5. Lubricate thoroughly on the inside surfaces and sparsely on the outside of the seal with Roxtec Lubricant
6. Insert the halves into the sealing sleeve
7. Tighten the screws crosswise. The seal will compress and seal the transit frame

Roxtec RS Cable Transit Frame - Installation Instructions RS25-644

Roxtec RS Cable Transit Frame – Installation Instructions RS25-644

1. Remove any dirt in the sleeve/hole
2. Pull the cable/pipe through
3. Fold out all stop flanges. Make sure that they are secured by the fittings
4. Adapt the seal to the cable/pipe by peeling off layers from the halves until you reach the gap seen in pic.5. The halves may not differ by more than one layer

Roxtec RS Cable Transit Frame - Installation Instructions RS25-644

Roxtec RS Cable Transit Frame – Installation Instructions RS25-644

5. Try to achieve a 0-1.0 mm gap between the two halves when held against the cable/pipe
6. Lubricate thoroughly on the inside surfaces and sparsely on the outside of the seal with Roxtec Lubricant
7. Insert the halves into the sleeve
8. Tighten the bolts crosswise. The seal will compress and seal the cable transit frame

Sealing Cables Ducts

Sealing Cable Ducts With Roxtec – cable sealing modules consist of two halves with removable layers and a centre core which is removed to permit cable or pipe installation in medium/high voltage substations, hazardous areas and electrical infrastructure

Roxtec Cable Transit Frames

Cable & Duct Sealing Transit Frames – T&D Approved Roxtec Distributor