Roxtec ComSeal Cable Transit Frame

Roxtec ComSeal Cable Transit Frames

Sealing Cables & Cable Ducts

Roxtec ComSeal cable transit frames are light-weight and are an area efficient entry seal frame for cabinets – the Roxtec frame is suitable for installation also around existing multiple or single pre-terminated cables and pipes in one opening.

Roxtec rectangular cable transit frames are used to provide a reliable cable sealing ensuring safety, efficiency and long-term operational reliability – Roxtec cable seals protect against fire, gas, water, dusts, pests, blast load and electromagnetic interference.

➡ Visit Cable Transits to view the complete range of sealing systems for cable and pipe entries on cabinets, switchgear, electrical enclosures and substations (LV 11kV 33kV 66kV 132kV) – see Round Cable Seals for sealing round type cable ducts and pipe entries.

Roxtec ComSeal Cable Transit Frame

Roxtec ComSeal cable transit frames are used with adaptable sealing modules.

Installing Roxtec ComSeal Cable Transit Frames

Contact T&D should you require support on the installation of Roxtec ComSeal cable transit frames:

Roxtec ComSeal Cable Transit Frame

  • 1. Cut a rectangular opening for the frame, according to the tables above. * ø5.5 (7/32″). Drill bit size when using nuts.

Roxtec ComSeal Cable Transit Frame

  • 2.  Remove the protective foil from the gasket. Fasten the gasket on the side of the flange facing the wall / structure.
  • 3. Insert the frame in the opening with the gasket side towards the structure.
  • 4. Attach the frame firmly, using the enclosed self-tapping screws.
  • 5. Lubricate the inside surfaces of the frame with Roxtec Assembly Gel, especially in the corners.

Roxtec ComSeal Cable Transit Frame

  • 6. Insert the cables through the frame.
  • 7. Adapt the modules, which are to hold cables or pipes. Peel off layers until you achieve the gap seen in pic. 8.
  • 8. Achieve a 0.1-1.0 mm gap between the two module halves when held against the cable.
  • 9. Lubricate all modules thoroughly, both on the inside and the outside surfaces, before installation.

Roxtec ComSeal Cable Transit Frame

  • 10.  Insert the modules from the back of the frame opening and according to the installation plan (Packing Plan). If possible, start with the largest modules.
  • 11. Tighten the compression unit firmly to seal the frame. Maximum 10Nm (7.38 ft. lb). A good indication is when the assembly gel is squeezed out between the modules.
Sealing Cables Ducts

Sealing Cable Ducts With Roxtec – cable sealing modules consist of two halves with removable layers and a centre core which is removed to permit cable or pipe installation in medium/high voltage substations, hazardous areas and electrical infrastructure

Roxtec Cable Transit Frames

Cable & Duct Sealing Transit Frames – T&D Approved Roxtec Distributor